SOYO SY-KT600 User Manual download pdf (Page 18)

SY-KT600 DRAGON Plus Quick Start Guide

Hardware

Installation

CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to

clear the CMOS memory.

1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. Its

white cap can easily identify this jumper.

2. Put the jumper back to 1-2 to allow writing of new data into the CMOS memory.

CMOS Clearing Clear CMOS Data Retain CMOS Data

JP5 Setting

Short pin 2-3 for

at least 5 seconds to

clear the CMOS

Short pin 1-2 to

retain new settings

Note: You must unplug the ATX power cable from the ATX power connector

when performing the CMOS Clear operation.

On-board Speaker connection

When using 2-channel speaker, connect the speaker cable to Line-out.

If you’re using 4 channel speaker, connect the front L/R speakers to Line-out and rear L/R speakers

to Line-in. Make sure that the audio software is set for 4 channel speaker system.

If you are using 6 channel speaker, connect the front L/R speakers to Line-out and the rear L/R

speakers to Line-in. Connect the Center/Bass to Mic-in.

Line-in

Line-ou

Mic

32 1

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

No comments

SOYO SY-KT600 User Manual Page 18